Splined socket wrench for the low-pressure connections. Hole diam 10 mm ( BH 0 986 611 489)

Splined socket wrench for the low-pressure connections. Hole diam 12 mm ( BH 0 986 612 991 )

Toolset for CP3 pumps. The following tools are included:
8133 - Clamping tool set for the pumping elements
8171 - Set of 6 sealing ring inserters
8172 - Puller for the shaft sealing ring (25mm)
8173 - Set of 7 O-ring inserters

Inserter bracket and oil seal for CP1 and CP3 pumps

Tool for the expulsion of the pump sprocket on BMW 520 TDS, 320D.
Similar to 0 986 613 170

8225-CP3 helps to determine if the ZME valve can be retained, instead of installing a new one, on CP3 and CP1-H pumps.
Similar to 0 986 613 270

Flexible High pressure line L=600 mm. - M12x1,5 - M12x1,5

Splined coupling to drive CP3.4 (MAN) pumps on any test bench.
Similar to 1 685 702 092

Torx bit
Similar to 0 986 613 145

Flexible pipe ( cr 2500BAR) to connect the high pressure delivery from the pump outlet to the rail. Similar to 1 680 712 324

This device allows to monitor the pump body pressure (5 BAR).
It is also equipped with ball valve, to measure the negative pressure generated by the pump.
Caution: Not all test benches are able to supply the amount of flow required by the comon rail pumps. Therefore, it is crucial to monitor that, during the test, the pump does not go into cavitation.

High pressure swivel fitting Male 14x1,5 - Female 12x1,5

High pressure swivel fitting Male 14x1,5 - Female 14x1,5

Ready for external lubrication by oil.

The flange 8155-E warrants the centered clamping of the majority of cr pumps (Bosch CP1, CP3, CP4, Delphi, Denso, VDO), on any test bench.
The flange is equipped with 4 rings of reduction to suite the 50, 60, 68, 80 mm hub diameters, as well as CP1K pumps.
The flange requires 9680-A universal cradle or similar.